- Make sure this fits by entering your model number.
- MPPT 60A Solar Charge Controller, High tracking efficiency > 99.5%, Peak Conversion Rate > 97.8%.
- 12V/24V/36V/48V auto identification, Max. PV Volt: 150V, Rated Charge Power: 720W(12V), 1440W(24V), 2160W(36V), 2880W(48V)
- Sealed, Gel, AGM, Flooded, Lithium battery types. 3-stage battery charging algorithm for rapid, efficient,and safe battery charging.
- Dual Fan Cooling design to achieve Higher Heat Dissipation. Green backlight LCD display to indicate the operate status, LED indicators show charging status and controller faults.
- 2 years warranty and professional after-sale service. Multiple protection against overcharge, over discharge, over load, short circuit, reverse polarity, over heat and battery under voltage.
MPPT charge Positive-Ground Controller
Rated DC load Current:60A
Max. PV Volt:150V
Self Consumption:2W
Bulk charge voltage: Sealed 14.4V~AGM Gel 14.2V~ Flooded:14.6V~ User define:10-15V
Float charge voltage: Sealed/Gel/AMG:13.7V~ Flooded:13.6V~ User define :10-15V
Equalize charge voltage: Sealed:14.6V~ AGM:14.8V~ Flooded:14.8V~ User define:10-15V
Load disconnect voltage:10.5V～12V adjustable
Low voltage reconnect voltage:12.5V
Temperature compensation: -5mV/℃ /2V with BTS(Optional)
Ambient Temperature: -25~60℃ ( Derating from 45℃)
Recommended wire sizes: 5# AWG
Enclosure:IP20
Net weight:6.5lb
Dimension:11.4in*7.1in*3.6in
●12V/24V/36V/48V auto identification
●Battery type: Sealed, Gel, AGM, Flooded, Lithium battery, User define (defined voltage for other battery by user)
●MPPT Efficiency ≥99.5%, Conversion Efficiency ≥97.8%
●Multi-stage charging mode
●Green backlight LCD display
●Fault warning LED
●Fan cooling Cooling
Input specification:
PV operating voltage
12V system: DC18V~DC150V
24V system:DC34V~DC150V
36V system: DC50V~DC150V
48V system: DC60V~DC150V
Rated Charge Power
12V system: 720W
24V system: 1440W
36V system: 2160W
48V system: 2880W
System Connection:
First–Connect the battery to the charge controller
Second–Connect the photovoltaic module to the controller
Third–Connect the consumer to the charge controller
NOTE: The reverse order applies when deinstalling! An improper sequence order can damage the controller!
CAUTION: If an inverter is to be connected to the system, connect the inverter directly to the battery, not to the load side of the controller.
Two Years Warranty, your Satisfaction is our Highest Priority, please kindly contact us via email: [email protected], thank you.